How To Put Bees In A Beehive

As a new beekeeper, one of your kickoff steps is really putting your bees in their new hive. Accept your fourth dimension and enjoy the experience. You'll observe that the bees are docile and cooperative. Read the instructions several times until yous get familiar and comfortable with the steps. Do a dry run earlier your girls make it.

Ideally, hive your bees in the late afternoon on the mean solar day that you pick them up, or the next afternoon. Pick a clear, mild day with trivial or no wind. If information technology'south raining and cold, wait a day.

To hive your bees, follow these steps in the society they are given:

30 minutes before hiving, spray your bees rather heavily with nonmedicated saccharide syrup.

Thirty minutes before hiving, spray your bees rather heavily with nonmedicated sugar syrup.

Only don't drown them with syrup. Use common sense, and they'll be fine.

Using your hive tool, pry the wood cover off the bundle.

Using your hive tool, pry the wood cover off the package.

Pull the nails or staples out of the comprehend, and proceed the woods embrace handy.

Jar the package down sharply on its bottom then that your bees fall to the bottom of the package.

Jar the package down sharply on its bottom so that your bees fall to the bottom of the package.

Information technology doesn't injure them! Remove the can of syrup from the package and the queen cage, and loosely replace the wood cover (without the staples).

Examine the queen cage. See the queen?

She's in in that location with a few attendants. Is she okay? In rare cases, she may have died in transit. If that's the case, go ahead with the installation equally if everything were okay. Simply phone call your supplier to order a replacement queen (there should be no accuse). Your colony volition be fine while y'all expect for your replacement queen.

Slide the metal disc on the queen muzzle to the side slowly.

Remove the cork at 1 end of the cage then that you can see the white candy in the hole. If the candy is present, remove the disc completely. If the candy is missing, you tin can plug the hole with a small-scale slice of marshmallow.

Out of two small frame nails bent at correct angles, fashion a hanging bracket for the queen cage.

Spray your bees again, and jar the package downwardly so the bees drop to the bottom.

Prepare the hive by removing five of the frames, but keep them nearby.

Remember that at this point in time y'all're using only the lower deep hive torso for your bees. At present hang the queen muzzle (processed side upwardly) between the center-well-nigh frame and the next frame facing toward the centre. The screen side of the muzzle needs to face toward the eye of the hive.

Spray your bees liberally with syrup one final time.

Spray your bees liberally with syrup one last time.

Jar the package down. Toss away the wood cover and and then pour (and shake) approximately half of the bees direct above the hanging queen cage. Cascade (and shake) the remaining bees into the open expanse created by the missing five frames.

When the bees disperse a bit, gently supplant iv of the 5 frames.

Do this gingerly so y'all don't crush any bees. If the pile of bees is as well deep, use your hand (with gloves on) to gently disperse the bees.

Place the inner cover on the hive.

If y'all're using a hive-top feeder, it is placed in direct contact with the bees without the inner cover in between, so skip this step and go to step 12. The inner cover is used only when a jar or pail is used for feeding. The outer cover is placed on top of the hive-top feeder.

Place the hive-peak feeder on height of the hive.

Alternatively, invert a one-gallon feeding pail above the oval hole in the inner cover; add together a second deep super on meridian of the inner cover; and fill the cavity effectually the jar with crumpled newspaper for insulation.

Plug the inner cover's half-moon ventilation notch with a dodder of grass (some inner covers exercise not accept this notch).

You lot desire to shut off this archway until the bees become established in their new dwelling house.

Now identify the outer encompass on top of the hive. Y'all're near done.

Insert your entrance reducer, leaving a ane-finger opening for the bees to defend.

Get out the opening in this manner until the bees build up their numbers and can defend a larger hive archway against intruders. This takes about four weeks. If an entrance reducer isn't used, apply grass to shut up all but an inch or two of the entrance.

About This Article

This article tin exist institute in the category:

Beekeeping ,

Source: https://www.dummies.com/article/home-auto-hobbies/hobby-farming/beekeeping/how-to-put-your-bees-in-the-hive-205909/